24V FAR INFRARED MATTRESS PAD
JPHEAT Pad Single
JPT100J / Far-infrared heated mattress pad
HK$1,320(+ shipping)Buy
As the day ends,
warmth to settle into.
Far-infrared warmth for your usual bedding.
The soft feel of cotton, and warmth that comes from a surface.
More comfort when you unwind.
- SIZE
- 190 × 100 cm
- Single, full-length
- POWER
- DC 24V
- Dedicated AC adapter included
- TECHNOLOGY
- Far infrared × planar heating
- Structure with no heater wire
TIME TO UNWIND
Open a book.
A slow breath.
A little more of a favorite book.
Time for doing nothing, slowly.
Your usual spot becomes a place of ease,
wrapped in warmth.
A full-length Single size, about 190×100 cm.
Spread it on your futon and cover it with a sheet.
Far-infrared warmth for your bedding.
JPHEAT / Product film
Warmth for
time to unwind.
One layer on your usual bedding.
Far-infrared warmth, and a moment to unwind.
The film is illustrative. In use, please lay the pad under a sheet.
The film could not be loaded. Open the film
JPHEAT / FAR INFRARED TECHNOLOGY
Warmth begins with
ORIZUMI planar heating.
The heat comes from a single heating element made with water-based carbon.
This is JPHEAT planar heating technology, with no heater wire.
The weave that makes warmth.
The light is illustrative.From the feel of cotton to the ORIZUMI heating element.
The structure and light are illustrative. Layer thickness and spacing are not to scale.
THE HEART OF WARMTH
From one ORIZUMI sheet
to everyday warmth.
ORIZUMI, a planar heating element made with water-based carbon.
It makes heat as a surface, with no heater wire.
JPHEAT warmth begins with this one sheet.
INSIDE THE COMFORT
5 layers, built up for comfort.
From the cotton outer fabric to the heat-spreading sheets around the heating element.
Each material has a role.
- 01
100% cotton outer fabricThe feel, and the soft look of the quilting
- 02
Heat-spreading sheetSpreads the heat of the element across a surface
- 03
ORIZUMI planar heating elementA heating element made with water-based carbon
- 04
Heat-spreading sheetWraps the heating element above and below
- 05
Quilted liningThe underside finish that rests on the futon
Wire heating example
Structure with heater wire
Heats along the wire
JPHEAT
Planar structure in all current products
A surface structure with no heater wire
Structure diagram, not a measured comparison of temperature distribution or performance.
LINE / SURFACE
Heats as a surface,
not a wire.
All current JPHEAT products share
a planar heating element with no heater wire.
A woven mesh of water-based carbon
makes heat when current flows.
MATERIAL / ORIZUMI
From a fine mesh
to a heating sheet.
Water-based carbon in a fine woven mesh.
When powered, the mesh itself heats.
Threads, not one wire, warm as a surface.
LIGHT / Far infrared
Unseen light,
as warmth.
Far infrared is a kind of unseen light.
A warmed surface gives off this light.
Absorbed by an object, it turns into heat.
JPHEAT / Into daily life
Different forms,
one heating technology.
For time on the floor, for time to unwind in bed.
One shared heating technology,
shaped for where it is used.
TECHNOLOGY IN MOTIONAuto-play / 24 SEC
MEASURED / JPT100J
We measured a test
sample of the JPT100J.
A test sample of the JPT100J was measured at a third-party testing laboratory.
The emission peak is about 8.35 μm, within the far-infrared (IR-C) range of the CIE classification.
Far infrared, by wavelength.
Beyond visible light,
the far-infrared range.
Infrared is light with a longer wavelength than visible light.
There are several standards for classifying it.
Shown here using the classification of the International Commission on Illumination (CIE).
The JPT100J test sample peak, about 8.35 μm, is in the IR-C range.[1]
The boundaries of near, mid and far infrared differ by field and use.
BOKEN, a textile evaluation body in Japan, describes 3–1,000 μm as far infrared.
The value here, about 8.35 μm, also falls in that range.[3]
Measuring emission characteristics.
Emission, checked
by wavelength.
Along with the structure, measurement data for a test sample is shown here.
This is something JPHEAT values in how it makes products.
A test sample of the JPT100J was measured at a third-party testing laboratory.
Relative intensity by wavelength is shown as one curve.
The wavelength at which relative intensity was highest among the recorded points.
This value shows emission characteristics under the test conditions. It does not indicate any action on the human body or compare power consumption.
Both are results for the test sample. Values differ with product construction and measurement conditions, even where the same heating material is used.
Measurement conditions and how to read the values
- Sample
- JPT100J test sample (1 piece)
- Report
- (2026) WT-HWGD-01049 / English version of the same report
- Testing laboratory
- Wuhan Inspection & Testing Certification Development Group Co., Ltd.
- Test method
- GB/T 7287-2008 (normal total emissivity: Article 18, Method B / relative emission spectrum: Article 20)
- Spectrum measurement date and environment
- 2026-09-17 / 20.0 °C, 40% RH (as stated in the report)
- Graph range
- 2.50–25.00 μm, at 0.05 μm intervals. Shows the recorded range. It does not mean there is no emission outside this range.
- Relative intensity
- Scaled so the maximum is 1. It does not represent absolute emitted energy, temperature distribution or any action on the human body.
All are results for the test sample. They do not show the surface temperature of each product or any action on the human body.
The structure of the planar heating element is a registered Japanese utility model.Utility Model Registration No. 3241938
Test details on the Technology page →COTTON / TEXTURE
Comfort, down
to the touch.
For the outer fabric, 100% cotton.
Quilting that pairs a floral pattern with fine vertical lines.
A soft texture, finished in a calm ivory.
TEMPERATURE & TIME
Settings, at hand.
Temperature from 20 °C to 50 °C in 1 °C steps. Off timer from 1 hour to 12 hours.
Setup takes just the four buttons.
1 °C steps
00 cancels
Start at a lower temperature and find the one that suits you. For long continuous use, about 30–38 °C is a guide.
This illustrates operation, with the display and lamps laid over a product photo. The numbers are an example. For actual operation, see the instruction manual.
DESIGNED FOR YOUR BEDDING
Lay it under the sheet.
Spread it on your futon and secure it with the elastic bands.
Add your usual sheet, and it is ready.
- 01
Flat, on the futon.
No folds, overlaps or wrinkles.
- 02
Hook the bands on the corners.
Secure with the underside bands. Fits futons about 9–13 cm thick.
- 03
Add a sheet on top.
Cover with a sheet, then set temperature and time on the controller.
DC24V / 90W
From a home outlet to DC 24 V.
The dedicated AC adapter converts AC to DC.
Rated power consumption of the unit is 90 W.
Adapter input: AC 100–240 V, 50/60 Hz.
UK 3-pin plug adapter included. It is not rechargeable.
CARE & STORAGE
Let it cool before storing.
Turn off the power and unplug it first.
Once the unit has cooled, it can be folded and stored.
The unit is not washable. Wipe off dirt with a damp, well-wrung cloth. Do not turn it on while folded.
SPECIFICATIONS
Specs
JPHEAT Pad Single / JPT100J
| Model | JPT100J |
|---|---|
| Product | 24 V far-infrared heated mattress pad / Single |
| Size | About 190 × 100 cm (outer dimensions) |
| Color | Ivory |
| Outer fabric | 100% cotton |
| Heating element | ORIZUMI planar heating element made with water-based carbon |
| Power supply / Rated power | DC 24 V low voltage (through the dedicated AC adapter) / 90 W |
| Dedicated AC adapter input | AC 100–240 V, 50/60 Hz |
| Temperature | 20–50 °C (in 1 °C steps) |
| Off timer | 1–12 hours |
| Fastening | Elastic bands on the underside (fits futons about 9–13 cm thick) |
| Included | Dedicated controller, dedicated AC adapter, power cord |
| Safety standard | Plug: UK 3-pin plug adapter included (Hong Kong / Macau version) |
| Designed / Made in | Japan / China |
| Warranty | 1 year (under the terms of the warranty card) |
| Utility model | Japanese Utility Model Registration No. 3241938 (structure of the planar heating element) |
The former product number is JPT100. Temperatures shown are set temperatures.
Safety information
- If a small child, an elderly person, someone who has trouble feeling heat or someone who cannot adjust the temperature alone uses this product, always stay nearby and watch over them.
- Start at a lower temperature and find the one that suits you. For long continuous use, set the temperature to about 30–38 °C as a guide. Staying in contact with the same spot at a higher temperature can cause low-temperature burns.
- Lay the unit under a sheet and do not use it in direct contact with your skin.
- At bedtime, please use the off timer.
- Before use, always read “Safety precautions” in the instruction manual.
What does DC 24 V (low voltage) mean?
Power from a household outlet (AC 220 V) is converted to 24 V DC by the included dedicated AC adapter, then sent to the unit. Just 24 V DC runs through the unit and the planar heating element. It is not rechargeable, so please keep the adapter plugged in during use.
Please check before use
Lay the unit flat and cover it with a sheet. Do not use it as a blanket or wrap it around your body. Do not turn it on while it has folds, overlaps or wrinkles.
Warming the same spot for a long time can cause low-temperature burns, even at relatively low temperatures. Start at a lower temperature. If an infant, an elderly person or someone who has trouble feeling heat uses this product, always stay nearby and watch over them. Do not use it to warm pets or for any other unintended use.
Care and storage
The unit is not washable. Turn off the power, unplug it and wipe off dirt with a damp, well-wrung cloth. When storing, fold it after the unit has cooled.
Warranty and product questions
The warranty period is 1 year. For details, please check the terms on the warranty card. Product questions are welcome by email.
info@jpheat.jp ↗
BRING THE WARMTH HOME
A little warmth
for time to unwind.
JPHEAT Pad Single
JPT100J / About 190 × 100 cm / Ivory
HK$1,320(+ shipping)
Shipping: HK$93 per item. Ships from our Asia-Pacific warehouse (Shanghai, China) by SF Express within 3 business days; delivery takes about 5–7 days.
Ordering from Hong Kong or Macau
- Hong Kong and Macau orders ship from our Asia-Pacific warehouse (Shanghai, China) by SF Express within 3 business days and arrive in about 5–7 days.
- At checkout, please enter the recipient’s real name (SF Express needs it for delivery).
- Power: the heated floor mats (JPT5060, JPT60100, JPT16060, JPT200120) are AC 220 V Hong Kong / Macau versions; the heated mattress pads use an AC 100–240 V adapter. Every product comes with a UK 3-pin plug adapter.
- Change-of-mind returns are not accepted. For an initial defect, damage in transit or a wrong item, email us within 7 days of delivery (info@jpheat.jp) and we will exchange it at our cost.
Payment is on the Shopify checkout page. You can use credit cards (VISA / Mastercard / JCB / American Express / Diners Club / Discover) and other methods; the checkout page shows what is available.
Ask about this productExchanges: for an initial defect, damage in transit or a wrong item, contact us within 7 days of delivery (details).